![]() In this case the heating is thought to arise from the interaction of the magnetic structure in the lower solar atmosphere with the convective motions mentioned above. The third explanation is quite different. Some of these waves allow for particularly efficient transmission and deposition of energy and so are favored by many theorists as the corona's heating source. These are analogous to pure sound waves, but their properties depend on the magnetic field strength and direction. (The fields located near sunspots are the strongest.) The presence of this magnetic field enables the energy from the boiling motion to propagate upward in a variety of ways as magnetohydrodynamic waves. The bubbling fluid of the photosphere is threaded by magnetic fields, some of which are many thousands of times as intense as Earth's field, but most of which are a good deal weaker. The second theory is really just an elaboration of the first. Because the coronal material is so thin and tenuous, only a tiny portion of all the sound energy in the photosphere needs to bleed up into the corona and be absorbed in order to heat it to the observed temperatures. At least some of this sound makes its way upward into the corona, where dissipative processes covert the audio energy into heat. Thus, if you could stand on the solar surface, not only would it be very hot but it would also be incredibly loud. And just as the roiling water makes noise, so does the convective overturning of the solar surface fill its atmosphere with intense sound waves. They fall into three main categories: In the first, the photosphere can be likened to the bubbling surface of boiling water it is a seething mass of rising and falling columns of hot fluid. That is, only in an ultra-low density medium, such as the corona, are collisions between atoms so infrequent that atomic populations can be maintained in the right kind of energy states to enable the observed emission.Īlthough these high coronal temperatures came as a surprise to early observers, it did not take long for theoretical explanations to surface. Finally, however, it was recognized that the observed color lines arise from what are known as forbidden emissions from very hot atoms (in the range of one million K or more) occurring under highly rarified conditions. For a time people speculated that the coronal emissions were due to coronium, a potential new element found only in the sun. Astronomers recorded red and green line emission from the corona during eclipses as early as 1867, but they could not associate them with any known laboratory spectra. For example, the characteristic brilliant red of the chromosphere seen during solar eclipses was readily traced via so-called Balmer line emissions from hydrogen to material at around 6,000 kelvins. Temperatures in the cooler photosphere (the visible surface of the sun, where we see sunspots) and the overlying chromosphere (where we best see prominences and the expanding magnetic structure in the lower solar atmosphere) had been determined long before that by spectroscopic observations. The fact that the sun's corona is very hot-one million to two million kelvins in "quiet" regions, two million to five million in magnetically strong active regions and higher yet in solar flares-was well established by the 1940s. The contribution from the corona is minuscule in comparison.Victor Pizzo, a physicist at the National Oceanic and Atmospheric Administration's Space Environment Center, explains. So although the Sun’s corona at a temperature of over a million kelvins (1,800,000 F ) is significantly hotter than the photosphere, the vast majority of the light we use to measure the effective temperature of the Sun comes from its photosphere. These different methods all show that the effective temperature of the Sun’s surface is around 5,800 kelvins (9,980 degrees Fahrenheit ). Another approach is to record which absorption lines are present in the solar spectrum and determine their strengths both the elements present and their strengths are sensitive to temperature. This means that we can determine the effective temperature of the Sun by measuring the amount of light it emits at each wavelength and comparing the resulting spectrum we see to models. The color of light a star emits is related to its temperature. In fact, the photosphere is often referred to as the “surface” of the Sun, even though there is no real solid surface. This is also why the corona can be seen only when the light from the photosphere is blocked (via a total eclipse or an occulting disk in a coronagraph). Because of this, the light we receive from the Sun overwhelmingly comes from its photosphere only a tiny fraction comes from its corona. ![]() The density of the plasma in the Sun’s atmosphere falls off precipitously as we move outward from the photosphere (its visible surface) to the corona.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |